Special gate valve to connect directly PE/PVC pipes, fully restraint by clamp ring with special interlocking teeth separated from the sailing system. Simply removing the clamp ring the model 1300 with sockets for PVC is obtained. Manufactured according to the requirements of EN 1074 and EN 1171 (min. torque strength Class2). Body and bonnet high quality EPOXY powder coated (fusion bonded), coating thickness DFT min. 250 micron, zero porosity (tested with 3000V), high impact resistance and cross-linkage according to DIN 30677-2 and DIN 3476. Multiple O-Ring spindle sealing system embedded in non-corrosive material to DIN 3547-1 and additional back lip-seal for double security. O-Rings changeable under pressure to ISO 7259. Non-rising stainless steel spindle (single forged round bar with rolled threading). Wedge inside and outside fully rubber vulcanised, with drain hole and special guiding rails to minimize friction. Solid flexible wedge nut from corrosion free material . Gliding disc on the spindle neck to reduce friction when operating the spindle. From DN 250 and bigger with additional axial roller bearing. Bolts protected against corrosion by special resin. Protection ring between body and bonnet to reduce risk of damages on the coating due to mechanical impacts during transport, handling and installation. Clamp ring with special interlocking teeth. Markings following EN 19. Manual operation by handwheel, operating cap, extension spindle (underground installation).

Materials

Body and bonnet: Ductile iron EN-GJS-400-15/EN 1563 (former to DIN GGG40)

Spindle: Stainless steel 1.4021/EN ISO 10088 (equivalent to UNI X20Cr13 or AISI 420)

Wedge: Ductile iron EN-GJS-400-15/EN 1563 (former to DIN GGG40), EPDM rubber vulcanised, potable water approved

Wedge nut: Brass CuZn40Pb2

O-Ring bush: Brass CuZn40Pb2

Gliding disc: POM

Back lip seal bonnet seal and dust cap: EPDM rubber, potable water approved

Bonnet allen screws: Steel class 8.8 to EN ISO 898-1, corrosion protected by special seal

Protection ring: Reinforced plastic material

Grip ring: Brass CuZn40Pb2

Bolts and washers for compression ring: Stainless steel A2-70 EN ISO 3506

Raci Spacers India Private Limited

Raci India was established in 2009 as a subsidiary of Raci SRL Italy to provide quality engineering solutions for the installation of oil and gas pipelines. Due to the sheer market's proximity to India, we began servicing the Middle East market in 2011.
In 2018, Flowheel FZE, the Middle East arm of RACI Pipeline Division of Raci SRL, Italy, began operations from Ras Al Khaimah Free Zone in the United Arab Emirates.
RACI has a significant presence in Iraq, Kuwait, Saudi Arabia, the UAE, Qatar, Bahrain, and Oman.
We work in both the water and oil and gas industries. Since 2018, Flowheel has been expanding its RACI business by entering into new partnerships and carving out a niche in the market from its Middle Eastern base.
In 2020, Flowheel and RACI India collaborated with Radlinger Primus Line Gmbh, Germany, to provide trenchless rehabilitation of underground pipelines in critical installations.